Sony BVM-14F5U Operation Manual page 16

Location and Function of Parts
6 Input option slots
The BVM-14F5U/14F5E/14E5U/14E5E may be fitted
with up to four adaptors.
7 REMOTE 1 connectors (female, D-sub 9-pin),
and TERMINATE switch
REMOTE 1
IN
TERMINATE
ON
OFF
OUT
These are RS-485 serial interface connectors, used for
connecting two or more BVM-series monitors.
The IN and OUT connectors form a loop-through
connection. Set the TERMINATE switch to OFF.
Connect two monitors using a straight cable with D-
sub 9-pin plugs such as an RCC-5G (not supplied) as
shown in the figure.
Monitor 1
REMOTE 1
IN
TERMINATE
ON
OFF
OUT
TERMINATE switch:
OFF
Straight cable with D-sub
9-pin plugs (not supplied)
12
REMOTE 1 IN connector
TERMINATE switch
REMOTE 1 OUT connector
Monitor 2
REMOTE 1
IN
TERMINATE
ON
OFF
OUT
TERMINATE switch:
OFF
8 REMOTE 2 connectors (female, D-sub 9-pin)
Forms a pararell switch and controls the BVM-14F5U/
14F5E/14E5U/14E5E externally. The pin arrangement
and factory setting function assigned to each pin are
given below.
5
Pin number Function
1 Set input signal channel 1 (numeric keypad
function)
2 Set input signal channel 2 (numeric keypad
function)
3 Select sync signal (SYNC button function)
4 Set the screen to monochrome, or set for
automatic switching based on the input signal
(MONO button function)
5 Safe area on/off (SAFE AREA button
function)
6, 7 Undefined
8 Tally lamp on/off
9 Ground
All pin function assignments can be changed with the
REMOTE menu.
For information about the REMOTE menu, see "Assigning
the Remote Control Functions —REMOTE Menu" on page
38.
To switch each function between on and off or
between enable and disable, change pin connections in
the following way.
On or enabled: Short each pin and pin 9 together.
Off or disabled: Leave each pin open.
9 ISR (Interactive Status Reporting) connector
(female, D-sub 9-pin)
Connect to the ISR system.
1
9 6