Setting The Clock - Sharp DK-A10 User Manual

D~~~JgK
Setting the clock
Press the ~ or ~ button to adjust the hour and then
press the CLOCK button.
Press the ~ or ~ button to select 12-hour or 24-hour
display and then press the CLOCK button.
Press the
~
or
~
button once to advance the time by
1 minute. Hold it down to change the time in 5-minutes interval.
You can press the CLEAR button to abort clock setting.
To confirm the time display:
[When the unit is in the stand-by mode or demonstration mode.]
Press the CLOCK button to enter the clock function.
[When the power is on]
Press DISPLAY button on the remote control to toggle between the
function information and clock display.
4
Press the
~
or
~
button to adjust the minutes and then
press the CLOCK button.
Notes:
• The clock will continue counting for 8 hours should there be a
power failure or the AC power cord becomes disconnected.
• The "CLOCK ADJ" will appear or time will flash to confirm the time
display when the AC power supply is restored after a power failure
or unplugging the unit after 8 hours. If incorrect, readjust the clock
as follows.
To readjust the clock:
Perform "Setting the clock" from step 1 to step 4.
To change the 12-hour or 24-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 30 for details.]
2 Perform "Setting the clock" from step 1.
Summer time:
The Summer Time switch is located on the rear of the unit.
1 Slide the Summer Time switch to
+
1 to advance
the time 1 hour.
~
indicator will appear.
SU~ERh
_I
2 Slide the Summer Time switch to -1 to turn the
TIME I I
clock back 1 hour.
+1 -1
SHARP
-
ON/
t:::\
STAND-BY
r
~et@
v
-
1~~~8
8
@08@
I
~e~
e
The 12-hour display will appear.
(12:00 AM - 11 :59 PM)
The 12-hour display will appear.
(0:00 AM - 11 :59 PM)
The 24-hour display will appear.
(0:00 - 23:59)
"12:00 AM" ~
~
"0:00AM"
~
~
I I I
Press the
~
or
~
button once to advance the time by 1 hour.
Hold it down to advance continuously.
In this example, the clock is set for the 12-hour (12:00 AM) display.
Press the CLOCK button for more than 2 seconds.
14