Setting The Clock - Sharp DK-A10H Operation Manual

Setting the clock

In this example, the clock is set for the 12-hour (12:00 AM) display.
1
Press the CLOCK button for more than 2 seconds.
2
Press the or button to select 12-hour or 24-hour
display and then press the CLOCK button.
The 12-hour display will appear.
"12:00 AM"
(12:00 AM - 11:59 PM)
The 12-hour display will appear.
"0:00 AM"
(0:00 AM - 11:59 PM)
The 24-hour display will appear.
"0:00"
(0:00 - 23:59)
3
Press the or button to adjust the hour and then
press the CLOCK button.
Press the or button once to advance the time by 1 hour.
Hold it down to advance continuously.
4
Press the or button to adjust the minutes and then
press the CLOCK button.
Press the or button once to advance the time by
1 minute. Hold it down to change the time in 5-minutes interval.
To confirm the time display:
[When the unit is in the stand-by mode or demonstration mode.]
Press the CLOCK button to enter the clock function.
[When the power is on]
Press DISPLAY button on the remote control to toggle between the
function information and clock display.
Notes:
The clock will continue counting for 8 hours should there be a
power failure or the AC power lead becomes disconnected.
The "CLOCK ADJ" will appear or time will flash to confirm the time
display when the AC power supply is restored after a power failure
or unplugging the unit after 8 hours. If incorrect, readjust the clock
as follows.
To readjust the clock:
Perform "Setting the clock" from step 1 to step 4.
To change the 12-hour or 24-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 34 for details.]
2 Perform "Setting the clock" from step 1.
Summer time:
The Summer Time switch is located on the rear of the unit.
1 Slide the Summer Time switch to +1 to advance
the time 1 hour. indicator will appear.
2 Slide the Summer Time switch to -1 to turn the
clock back 1 hour.
DK-A10H
DK-A10H(BK)
13