Technical Specifications; Conformity Certificates - Husqvarna 450 Operator's Manual

Weight and Dimensions 450
Weight – dry
Weight with gasoline and oil full
Length
Width
Height
Blade
Material cut
Blade type
Blade rotation
Blade shaft speed
Cutting depth
Cutting distance from wall
Average cutting rate - Estimate only. Speed will vary with job conditions and concrete mixes.
Soft aggregates
Medium aggregates
Hard aggregates
Engine:
Engine oil volume
Gasoline tank volume
Type
Air filter
Oil system
Muffler
Emissions
Cooling
Cylinder
Controls
CALIFORNIA AIR RESOURCES BOARD (CARB): This machine is considered a preempt Off-Road
Ap plication as relating to CARB standards. Under construction equipment, and in particular, as a Saws :
concrete, masonry, cutoff, with engine power less than 19KW (25hp), CARB standards do not apply to this
machine.
For more information see the website http://www.arb.ca.gov/msprog/offroad/preempt.htm

TECHNICAL SPECIFICATIONS

CONFORMITY CERTIFICATES

132 lbs 60 kg
139 lbs 63 kg
34 inch 864 mm
19 inch 483 mm
21 inch 533 mm
Green concrete only
8.0" (203 mm) dry cut with tri-arbor
Counter clockwise, upcutting
3350 rpm
1 to 1 3/16 inch (25 to 30 mm) depending on amount of
blade wear
3 inch 76 mm
13 ft/min 4.0 m/min
9 ft/min 2.7 m/min
5 ft/min 1.5 m/min
Robin EX17
0.6 quart 0.6 liter
1.0 gal 3.6 liter
Air cooled, 4-cycle, single slant cylinder, overhead
camshaft, gasoline engine
Cyclonic type
Oil alert with auto shut down sensor
Silent type 77 dbA, exhaust deflector, spark arrestor
Complies with EPA Phase 2 and CARB Tier II USA
regulations
Air cooled with internal and external cooling fins
Aluminum with cast iron liner
Engine mounted manual throttle, choke and fuel shut
off levers, manual on/off switch
14