Uninstall Washer And Dryer; If Your Washer Or Dryer Is Still In Its Packaging - Whirlpool For use only with front load washer and dryers Installation Instructions Manual

Stack kit for use only with front load washer and dryers
Table of Contents

Advertisement

Available languages

Available languages

Uninstall Washer and Dryer

IMPORTANT: If your washer and dryer are already installed, they
must be uninstalled.
If you need to uninstall your washer or dryer, see Installation
Instructions that came with your model for tools required.
WARNING
Excessive Weight Hazard
Use two or more people to move washer or dryer.
Failure to do so can result in back or other injury.
Uninstalling Your Washer
1. Turn off the hot and cold water faucets.
2. Unplug the power supply cord.
3. Slowly loosen the fill hoses at the faucets to relieve the water
pressure. Use a sponge or towel to absorb the released water.
4. Remove the "HOT" and "COLD" fill hoses from the back of
the washer. Drain water in the hoses into a bucket.
5. Remove the drain hose from the wall drain pipe or utility sink
and drain any water in the hose into a bucket.
Uninstalling Your Electric Dryer
1. Unplug the power supply cord.
2. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
4
Uninstalling Your Gas Dryer
1. Unplug the power supply cord.
2. Turn off the gas supply.
3. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
4. Disconnect the flexible gas supply line from the dryer. Put a
piece of tape over the open ends of the gas line connection
fittings.

If Your Washer or Dryer is Still in Its Packaging

WARNING
Excessive Weight Hazard
Use two or more people to move washer or dryer.
Failure to do so can result in back or other injury.
Position the packaged washer or dryer close to its final position.
Cut the packaging as follows:
■ Washer: Cut plastic film along dotted cut line around the
base. Remove the packaging. Do not remove the shipping
bolts.
■ Dryer: Cut carton around top and down corners along dotted
cut lines. Discard carton top, corner posts and sides. Leave
carton bottom underneath dryer.

Advertisement

Table of Contents
loading

This manual is also suitable for:

8572553a

Table of Contents