Operation
Attaching the base unit
The base unit is attached to a sheet of paper or block with its clip (A).
1. Position the base unit on the paper.
2. In the "Configuration" menu select the command "Base unit orientation".
3. In the dialogue box which then opens select the option for the current
base unit orientation and close the dialogue box with [OK].
Note: If the actual orientation of the base unit does not match the selected
option, the digital pen does not work correctly.
Silvercrest DGP1000
The best position for the base unit is at the top cen-
tre of the sheet of paper or block
If this is not possible due to the block type, attach
the base unit to the side of the block, either at the
top left (if you are right-handed) or top right (if you
are left-handed)
English
21