Kenwood SC5000 Instruction Manual page 5

When KENWOOD STEAM MOP 5000 starts to release steam, you can use it by passing it slowly over the
surfaces to be cleaned.
When the STEAM MOP 5000 runs out of water you simply place the unit on the heating pad to avoid floor
damage, then unplug the appliance and fill tank as described previously. During this operation, do not
touch the appliance's hot base (A).
If you need to leave the STEAM MOP unattended momentarily, place on the pre-heating pad, position the
handle vertically, it will clip into the upright position.
Before using the appliance again, unwind the power cord completely. Be sure the power cord is completely
unwound before you plug it in.
DO NOT LEAVE in one spot for more than 15 seconds as it may cause a whitish halo to form on the sur-
face. This is no call for concern as it may be removed using a normal decalcifying product or with a few drops
of vinegar.
DO NOT USE VINEGAR OR OTHER DECALCIFYING SUBSTANCES.
If the steam supply drops noticeably during use, the water flow from the outlet hole at the bot-
tom of the water tank may be blocked or restricted. We recommend to remove the water tank
and clean the outlet with a very fine needle (see fig. 6). Take care not to use excessive force
during the cleaning operation which could enlarge the hole.