Siemens SIMATIC Industrial Flat Panel IFP1500 Operating Instructions Manual page 73

The table below describes the test numbers of the HMI device classes:
Manufacturer site
Siemens AG
Industry Sector
Werner-von-Siemens-Straße 50
D-92209 Amberg, Germany
FCC and Canada
USA
Federal
Communications
Commission
Radio Frequency
Interference
Statement
Shielded Cables
Modifications
Conditions of
Operations
CANADA
Canadian Notice
Avis Canadien
AUSTRALIA / NEW ZEALAND
This product meets the requirements of EN 61000-6-4:2007 Generic standards - Emission
standard for industrial environments.
This product meets the requirements of the standard EN 61000-6-4:2007 Generic standards
– Emission standard for industrial environments.
KOREA
This product meets the requirements of Korean certification.
This product satisfies the requirement of the Korean Certification (KC Mark).
이 기기는 업무용(A급) 전자파 적합기기로서 판매자 또는 사용자는 이 점을 주의하시기
바라며 가정 외의 지역에서 사용하는 것을 목적으로 합니다.
Industrial Flat Panel IFP1500, IFP1900, IFP2200
Operating Instructions, 06/2014, A5E31298376-AB
HMI device class
Comfort Panel, ITC, IFP
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Shielded cables must be used with this equipment to maintain compliance with
FCC regulations.
Changes or modifications not expressly approved by the manufacturer could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003 (B).
Cet appareil numérique de la classe A est conforme à la norme NMB-
003 (B) du Canada.
Technical information
7.1 Certificates and approvals
Test number
DEKRA11ATEX0005X
IECEx DEK 13.0085X
73