Cisco ASR 5000 Series Administration Manual page 68

▀ Configuring the System to Perform as a Standalone HSGW
Notes:
This configuration is provided as a sample for a configuration file. It is the same configuration that is provided in
the "Using the CLI for Initial Configuration" procedure in the Getting Started chapter of the System
Administration Guide.
Remote access is configured using the command as shown in the local context above. Multiple server types are
available. For more information on remote access server types, refer to the Configuring the System for Remote
Access section in the Getting Started chapter of the System Administration Guide and the Context
Configuration Mode Commands chapter in the Command Line Interface Reference.
Creating and Configuring an HSGW Context
Use the following example to create an HSGW context and Ethernet interfaces, and bind the interfaces to configured
Ethernet ports. The interfaces created in this configuration support the A10/A11 connection to the eAN/ePCF and the
connection to the P-GW.
▄ Cisco ASR 5000 Series HRPD Serving Gateway Administration Guide
HSGW Configuration
OL-22984-01