Antenna Cable Connection - Toshiba D-VR660KU Owner's Manual

ANTENNA CABLE CONNECTION

This section describes how to connect your unit to an antenna, cable box, etc.
1
Disconnect the power cord of your TV from the AC outlet.
2
Disconnect RF coaxial cable from antenna input jack of your TV.
1 1
disconnect
3
Connect cables to the unit.
Make the basic connection as illustrated below.
HDMI OUT
DVD/VCR
S-VIDEO IN --- AUDIO --- OUT
L
R
IN
IN --- VIDEO --- OUT
RCA audio RCA video
cable cable
R L
AUDIO IN VIDEO IN
4
Plug in the power cord of this unit and your TV to the AC outlet.
connect
Note
• For your safety and to avoid damage to the device, please unplug the RF coaxial cable from the ANTENNA IN jack
before moving the unit.
• If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be
more effective than set-top versions.
• RF output is for tuner pass through only. DVD playback through the RF is not possible.
rear of your TV
ANT. IN
2
disconnect
rear of this unit
OUT
DVD DVD/VCR
DIGITAL AUDIO S-VIDEO COMPONENT S-VIDEO IN --- AUDIO --- OUT
AUDIO OUT OUT VIDEO OUT
Y L L
IN
ANTENNA
P
B
L R R
OUT /C IN
B
IN --- VIDEO --- OUT
P
R
/C R
rear of your TV
ANT. IN
rear of your TV
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your
local store.
* Once connections are completed, turn on the TV and
initial setting begin.
rear of this unit
Channel scanning is necessary for the unit to memorize
HDMI OUT
all available channels in your area.
DVD
DIGITAL AUDIO S-VIDEO COMPONENT
AUDIO OUT OUT VIDEO OUT (Refer to "INITIAL SETTING" on page 26.)
L OUT
COAXIAL
R
or
RF coaxial cable
OUT
IN
ANTENNA
RF coaxial cable RF coaxial cable
This connection is for
TV loop through only
OUT
DVD/VCR
S-VIDEO IN --- AUDIO --- OUT
Y L L
IN
ANTENNA
P B
R R
IN
/C B
IN --- VIDEO --- OUT
P R
/C
R
VHF / UHF
antenna
cable TV
company
VHF / UHF
antenna
or
cable TV
company
EN 19