A
F
B
B-1.
I
B-2.
A
C
G
B
D
22
D
C
E
I
G
H
I
E
D
F
H
F
7. Electrical work
E
7.3. Remote controller
1) Installing procedures
(2) Seal the service entrance for the remote controller cord with putty
to prevent possible invasion of dew drops, water, cockroaches or
worms.
A For installation in the switch box:
•
When the remote controller is installed in the switch box, seal the junc-
tion between the switch box and the conduit tube with putty.
B For direct installation on the wall select one of the following :
•
Prepare a hole through the wall to pass the remote controller cord (in
order to run the remote controller cord from the back), then seal the
hole with putty.
•
Run the remote controller cord through the cut-out upper case, then
seal the cut-out notch with putty similarly as above.
B-1. To lead the remote controller cord from the back of the control-
ler:
B-2. To run the remote controller cord through the upper portion:
C Wall
D Conduit
E Lock nut
F Bushing
G Switch box
H Remote controller cord
I Seal with putty.
7.3. Remote controller
1) Installing procedures
(3) Install the lower case in the switch box or on the wall.
A For installation in the switch box
C Switch box for two pieces
D Remote controller cord
E Cross-recessed, pan-head screw
F Connect to the connector CN1 on the upper case
G Seal the remote controller cord service entrance with putty
B For direct installation on the wall
H Wood screw
Caution:
Do not over-tighten the screws to possible deformed or broken lower
case.
Note:
•
Select a flat place for installation.
•
Be sure to use two or more locations for securing of the remote
controller in the switch box or on the wall.