Selecting Audio Signals - Sony SRW-5000 Operation Manual

5-1 Preparing for Recording

5-1-2 Selecting Audio Signals

This section describes how to select the audio signals
for input and monitoring.
Selecting the audio input signals
Proceed as follows to select the audio input signal and
channels.
1
1
1
Press the AUDIO button, and in the AUDIO menu
press the [F1] (AUDIO IN) button, to access the
AUDIO INPUT menu.
2
Make the audio input signal settings for each
channel.
SDI: audio signal input from the HD SDI INPUT
A/B connector
AES/EBU: audio signal input from the DIGITAL
I/O (AES/EBU) connector
Making settings for individual channels with
the F buttons
By pressing any of the [F1] (A-IN CH1) to [F8] (A-IN
CH8) buttons in the AUDIO INPUT menu, and in the
ALT+AUDIO screen obtained by pressing the ALT
button, the [F1] (A-IN CH9) to [F4] (A-IN CH12)
buttons, you can select the type of input signal for each
channel.
Making input signal selections for individual
channels with the numeric buttons
1
Press the cursor T or t button, to align the
cursor with the channel for which you want to
make the selection.
5-2
Chapter 5 Recording/Playback
2
Press the cursor R or r button, to select the signal.
To return to the default settings
Press the center cursor button.
To select the same input signal
simultaneously on all twelve channels
Press the [F9] (A-IN ALL) button.
This changes the input signal simultaneously on all
twelve channels.
You can also make this setting using the VTR SETUP
menu item 830 "AUDIO INPUT SELECT".
Selecting audio signals to be monitored
With the MONITOR L or R buttons at the upper left of
the control panel, switch the audio signal output from
the PHONES jack and MONITOR OUTPUT L/R
connectors as follows.
2
1
Check the audio level display area in the color
display, and make sure that the unit is not in the
REC LEVEL/PB LEVEL setting state (with red or
blue vertical lines appearing on the left and right of
the audio level meter).
The channels for which the signals are currently
being monitored are shown by reverse video
characters "L" and "R" below the audio level
meter.
2
Press the buttons corresponding to each channel, to
light the L/R reverse video indications below the
audio level meter, and specify channels 1 to 12
with the MONITOR L or R button (both L and R
can also be specified).