Selecting Audio Signals - Sony SRW-5800 Operation Manual

5-1-2 Selecting Audio Signals

This section describes how to select the audio signals for
input and monitoring.
Selecting the audio input signals
Proceed as follows to select the audio input signal and
channels.
1
Press the AUDIO button, and in the AUDIO menu
press the [F1] (AUDIO IN) button, to access the
AUDIO INPUT menu.
2
Make the audio input signal settings for each channel.
SDI: Selects audio signal input from the HD SDI
INPUT A/B connector.
AES/EBU: Selects audio signal input from the
DIGITAL I/O (AES/EBU) connector.
SDI96: Selects audio input from the HD SDI INPUT
connecters as the signal whose sampling frequency is
96K.
AES96: Selects audio input from the DIGITAL I/O
(AES/EBU) INPUT connectors as the signal whose
sampling frequency is 96K.
On recording/playback mode of this unit and audio
input signal setting
Depending on the recording/playback mode of this
unit, audio input signal setting on one channel applies
to two or four adjacent channels, as follows.
Recording/playback mode
• 4:4:4 HQ (XYZ/RGB)
• 4:2:2 1080P
• Dual-stream (3D)
• 4:2:2 1080i/PsF
• 4:4:4 SQ RGB
• 4:2:2 720P
118
5-1 Preparing for Recording
Audio input signal
setting
Applies to two
adjacent channels.
Applies to four
adjacent channels.
Note
"SDI96" and "AES96" appear only when the serial
number of this unit is 12001 and higher and the VTR
SETUP menu item 842 "AUDIO INPUT/OUTPUT
SAMPLING FREQUENCY" is set to "96K".
To make settings for individual channels with the
F buttons
By pressing any of the [F1] (A-IN CH1) to [F8] (A-IN
CH8) buttons in the AUDIO INPUT menu, and the [F1]
(A-IN CH9) to [F4] (A-IN CH12) buttons in the
ALT+AUDIO screen obtained by pressing the ALT
button, you can select the type of input signal for each
channel.
To make input signal selections for individual
channels with the numeric buttons
1
Press the cursor T or t button, to align the cursor
with the channel for which you want to make the
selection.
2
Press the cursor R or r button, to select the signal.
To return to the default settings
Press the cursor center button.
To select the same input signal simultaneously
on all twelve channels
Press the [F9] (A-IN ALL) button.
This changes the input signal simultaneously on all twelve
channels.
You can also make this setting using the VTR SETUP
menu item 830 "AUDIO INPUT SELECT".
Selecting audio signals to be monitored
With the MONITOR L or R buttons at the upper left of the
control panel, switch the audio signal output from the
PHONES jack and MONITOR OUTPUT L/R connectors
as follows.
1
Check the audio level display area in the color display,
and make sure that the unit is not in the REC LEVEL/
PB LEVEL setting state (with red or blue vertical lines