Problems When Projection Starts; Problems With The Remote Control; Problems With 3D - Epson EH-TW6000W User Manual

Troubleshooting

Problems when projection starts

The projector does not turn on
Check
Is the power turned on?
Is Child Lock set to On?
Is Control Panel Lock set to On?
Are the indicators switched off?
Do the indicators turn on and off when the
power cable is touched?

Problems with the remote control

The remote control does not respond
Check
Is the remote control light-emitting area
pointing towards the remote receiver on the
projector during operation?
Is the remote control too far from the projec-
tor?
Is direct sunlight or strong light from fluores-
cent lamps shining onto the remote receiver?
Are the batteries dead or have the batteries
been inserted correctly?

Problems with 3D

Cannot project correctly in 3D
Check
Are the 3D Glasses turned on?
Is the input image in 3D?
Press the button on the remote control or the
on the control panel.
When Child Lock is set to On from the configuration menu, hold
down the button on the control panel for approximately
three seconds, or perform operations from the remote control.
Settings - Lock Setting - Child Lock
s
If Control Panel Lock is set to On from the configuration menu,
all of the control panel buttons except for
form operations from the remote control.
Setting - Control Panel Lock
Disconnect and then reconnect the projector's power cable.
Check that power is being supplied.
Turn off the projector, and then disconnect and reconnect the
projector's power cable. If the problem continues, stop using the
projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest projector information
Epson Projector Contact List
center.
s
Point the remote control towards the remote receiver. Also,
check the operating range.
Check the operating range.
Set the projector up in a location where strong light does not
shine onto the remote receiver.
Make sure the batteries are inserted correctly or replace the bat-
teries with new ones if necessary.
Turn on the 3D Glasses. Also, check that the insulation tape in
the battery section has been removed.
Check that the input image is 3D compatible.
74
Remedy
p.61
are disabled. Per-
Settings - Lock
s
p.61
Remedy
p.21
s
p.21
s
p.21
s
Remedy
button