Charging the Scanner Battery
To charge the CS3000 series scanner, connect it to a host PC via the USB host cable or charging cradle. No power
supply is necessary. Charge time is approximately three hours for a fully discharged battery.
NOTE To check the battery charge status, hold the scan (+) button for 15 seconds. See
Table 2-1 on page
Charging via USB Host Cable
Remove the protective cover from the scanner.
1.
Removing Protective Cover
Figure 1-4
Insert the mini-USB connector on the host cable in the interface port on the scanner.
2.
Connect the other end of the host cable to a USB port on the host PC.
3.
Connecting Scanner to Host PC
Figure 1-5
2-3.
Getting Started
1 - 3
Battery charge status
in