Sony PVM-2541 Operating Instructions Manual page 30

Submenu
PARALLEL REMOTE
30
Adjustment Using the Menus
Setting
Selects the PARALLEL REMOTE
connector pins for which you want
to change the function.
You can assign various functions to
1 to 4 pins and 6 to 8 pins. The
following lists the functions you
can assign to the pins.
• – – – ("– – –": No function is
assigned.)
• COMPOSITE
• HDMI
• SDI 1
• SDI 2
• WFM/ALM
• OVERSCAN
• NORMAL
• NATIVE
• 4:3
• 16:9
• TALLY R
• TALLY G
• BLUE ONLY
• MONO
• H/V DELAY
• 16:9 MARKER
• 15:9 MARKER
• 14:9 MARKER
• 13:9 MARKER
• 1.85:1 MARKER
• 2.35:1 MARKER
• 1.85:1 & 4:3 MARKER
• 4:3 MARKER
• CENTER MARKER
• MARKER MAT HALF
• SAFE AREA 80%
• SAFE AREA 85%
• SAFE AREA 88%
• SAFE AREA 90%
• SAFE AREA 93%
• FLICKER FREE
Notes
• If you use the PARALLEL
REMOTE function, you need to
connect cables. For more details,
see page 33.
• Set MARKER ENABLE
(page 26) to ON to control the
aspect marker and center
marker.
Submenu Setting
FORCED TALLY The tally lamp function is forcibly
assigned to 7 pin and 8 pin of the
PARALLEL REMOTE connector.
Selecting ON assigns tally lamp
green to 7 pin and tally lamp red to
8 pin.
Note
When OFF is selected, any listed
functions can be assigned to 7 and 8
pins. Selecting ON with any
function other than the tally lamp
assigned to 7 and 8 pins will ignore
this setting, and the tally lamp is
forcibly assigned to 7 and 8 pins
instead.
ON: Forcibly assigns the
tally lamp function.
OFF: The tally lamp
function is not forcibly
assigned.