Audio Output Routing Window - Sony DMX-R100 Operating Instructions Manual

AUDIO OUTPUT ROUTING Window

To open this window, touch the AUDIO button on the
bottom menu bar, then select "OUTPUT ROUTING".
This window allows you to assign the desired bus
output signal to the desired output connector.
2 V buttons
1 Bus select button
2 v buttons
3 DEFAULT button
1 Bus select button
Displays the block (or bus) currently selected.
Touch this button to open the list for the bus block by
8 outputs in the B direction. Touch the desired bus
block to open the list of the busses included in the
block.
The list of the block and its output bus list are as
follows:
• PGM L/R
L and R
• AUX
This block has a list of 8 channels.
• MTR
This block has a list of 8 channels.
• INS SEND
This block has a list of 8 channels.
• DIRECT OUT 1 to 8 to 41 to 48
Each block has a list of 8 channels.
• MSC
NC (NO CONNECTION)
Block list
4 Output connector select buttons
Bus list
2 v/V buttons
Touch the V button to select the block over the
currently selected block.
Touch the v button to select the block below the
currently selected block.
3 DEFAULT button
Touch this button to reset the setting of the output
matrix to the default.
4 Output connector select buttons
SLOT 1 to 4, AUX SEND 1 to 8, PGM L/R
Selects the output connector to which the bus block
selected by the bus select button is routed.
Each of SLOT 1 to SLOT 4 has 8 output connectors.
5 INSERTION buttons
51
Chapter 3 Menu