Audio Output Routing Window - Sony DMX-R100 Operating Instructions Manual

AUDIO OUTPUT ROUTING Window

To open this window, touch the AUDIO button on the
bottom menu bar, then select "OUTPUT ROUTING".
This window allows you to assign the bus output
signal to the desired output connector.
2 V button
1 Bus select button
2 v button
3 DEFAULT button
1 Bus select button
Displays the block (or bus) currently selected.
Touch this button to open the list for the bus output
blocks in the B direction. Touch the desired bus block
to open the list of the busses included in the block.
The list of the block and its output bus list are as
follows:
• PGM L/R
L and R
• AUX
This block has 8 busses (AUX 1 to 8).
• MTR
This block has 8 busses (MTR 1 to 8).
• INS SEND
This block has 8 busses (Insert Send 1 to 8).
• DIRECT OUT 1 to 8 to 41 to 48
Each block has 8 outputs.
Block list 4 Output connector select buttons
6 PGM DITHER section
• MISC
This block has NC (NO CONNECTION), CR
MONITOR 1 to 6 and ST MONITOR L/R.
Touching NC opens NC 8 (adjacent 8 outputs are
simultaneously set to NO CONNECTION).
2 v/V buttons
Touch the V button to select the block above the
selected block.
Touch the v button to select the block below the
selected block.
3 DEFAULT button
Touch this button to reset the setting of the output
matrix to the default.
5 INSERTION buttons
65
Chapter 3 Menu