Sharp AL-1000 Service Manual page 34

AL-1000/1010
D. Charger wire cleaning
(1) Remove the charger cleaner from the manual paper feed
unit.
1)
(2) Set the charger cleaner to the transfer unit, and move it
reciprocally a few times in the arrow direction shown in the
figure below.
3)
4)
2)
1)
E. Charger wire replacement
(1) Remove the TC cover and remove the screw.
(2) Remove the spring and remove the charger wire.
(3) Install a new charger wire by reversing the procedures (1)
and (2). At that time, be careful of the following items.
The rest of the charger wire must be within 1.5mm.
The spring hook section (charger wire winding section)
must be in the range of the projection section.
Be careful not to twist the charger wire.
1)
Charger wire
Protrusion
8-2
3)
1)
2)
1mm
1.5mm