Table of Contents
Advertisement
Setup Menu
Touch Panel Adjust
You can adjust the touch panel operations.
1
Display the Touch Panel Adjust screen
Touch
If
is not shown, touch
Touch
Prev.
or
to display it.
Next
4
1
3
Set
2
1
1 Adjusts the volume.
2 Returns to the Control screen of the previous
source.
3 Calls the Sound Effects Menu. (see page 68)
4 Calls the Setup Menu.
5 Allows you to start touch panel adjustment.
2
Start to adjust the touch panel
Set
1
2
Cancel
Reset
1 Cancels the adjustment and returns to the Touch
Panel Adjust screen.
2 Resets to the initial status.
62 English
3
Adjustment
Touch the center of left lower and right upper
when requested.
Clock
1
Adjusts the clock time
1
Display the Clock Screen
5
Clock
1
If
is not shown, touch
Clock
or
to display it.
Next
4
1
6
7
3
5
2
6
7
1
1 Adjusts the volume.
2 Returns to the Control screen of the previous
source.
3 Calls the Sound Effects Menu. (see page 68)
4 Calls the Setup Menu.
5 Clock time display.
6 Adjusts hours.
7 Adjusts minutes.
8 Sets "00" minute.
Setup examples: 3:00~3:29 → 3:00
3:30~3:59 → 4:00
9 Sets the clock time in synchronous with the time
data sent from the RDS station. <Function of KVT-
935DVD (PAL TV type)> (
On)
When turned "On", the synchronous mode starts
and the clock cannot be adjusted manually.
2
Adjust the clock time
Security Code Setup
You can set a security code to protect your
receiver system against theft.
When the Security Code function is activated, the
code can't be changed and the function can't be
released.
Note, the Security Code can be set as the 4 digit
number of your choice.
1
Display the Security Code Setup screen
Security
If
Security
or
Next
4
1
3
Prev.
2
1
8
1
1 Adjusts the volume.
9
Off
2 Returns to the Control screen of the previous
1
source.
3 Calls the Sound Effects Menu. (see page 68)
4 Calls the Setup Menu.
5 Allows you to start security code registration.
If you have already completed the code
registration, the
2
Start the security code registration
Set
PassWord
＊＊＊＊
1
1
4
7
1 Enters a security code.
2 Clears your entry.
3 Cancels the registration and returns to the
Security Code Setup screen.
4 Enters the security code.
3
Enter a security code
Input a four-digit number.
4
Register your security code
is not shown, touch
Prev.
to display it.
5
Reenter the security code
1
Reenter the same security code as that you have
5
Set
entered in Step 3 for confirmation.
If you enter a different security code, the screen
returns to Step 3 (for the first code entry).
1
6
Register the security code again
Your security code has been registered.
If you press the Reset button or if you disconnect
your Receiver from the battery after the code
registration, you need to enter the registered
security code. See below for details.
Set
is not displayed.
If you have pressed the Reset button or if you
have disconnected the Receiver from battery...
1
Enter the correct security code
3
Cancel
You must enter the same security code as that you
1st
have entered in Step 3 above.
2
3
5
6
2
Enter the security code
8
9
0
4
2
Enter
Clear
Now, you can use your Receiver.
9
0
—
Enter
Enter
9
0
—
Enter
English 63
Advertisement
Table of Contents
