Recording With Automatic Switch-Off (Otr One-Touch Recording); Timer Programming; Timer Programming With 'Video Plus - Philips DVDR1000 Instructions For Use Manual

Recording with automatic switch-off (OTR
One-Touch Recording)
CLEAR SELECT
TIMER
a P
MUTE
T/C TUNER
Insert a recordable DVD+RW disc.
Use CHANNEL 3 or CHANNEL 4 (on the
recorder) or P+, P- or the digit keys 0-9 (on the
remote control) to select the programme number
(programme name) from which you wish to record.
Press RECORD (on the recorder) or REC/OTR
(on the remote control) twice.
A recording will be made of 30 minutes.
The required end time of the recording is shown
in the timer box on screen. The remaining recording
time is shown in the status box on screen and on
the display.
10: 15
Press RECORD or REC/OTR again to obtain a
30 minute increment.
Shortly after pressing REC/OTR, OTR can be
cancelled by pressing CLEAR.

Timer programming

The DVD recorder needs the following information for
every programmed recording:
- the date on which the recording is to be made;
- the channel;
- the start and stop time of the recording;
- VPS/PDC on or off;
- the recording mode (HQ, SP, LP or EP).
The DVD recorder stores all the information mentioned
above in a timer block. You can programme up to six
timer blocks, one month in advance.
TV/DVD STANDBY
REC/OTR
STOP PLAY
REVERSE PAUSE SLOW FORWARD
PREVIOUS NEXT
What is 'VPS'/'PDC'?
With 'VPS/PDC', the TV station controls the
beginning and the length of the programmed
recording. This means that the video recorder
switches itself on and off at the right time even if a
TV programme you have programmed begins earlier
or finishes later than expected.
Usually the start time is the same as the VPS/PDC
time. If, however, in the TV guide, in addition to a TV
programmes start time, a different VPS/PDC time is
given, e.g.: '20.15 (VPS 20.14)', you must enter '20.14'
as the start time exactly to the minute. If you want
to enter a time that differs from the VPS/PDC time,
you must switch off 'VPS/PDC'.
When all Timer blocks are full, the options timer
programming and VIDEO Plus+ programming cannot be
accessed. For clearing a timer block, see 'How to clear a
timer block'.

Timer programming with 'VIDEO Plus+'

CLEAR
A PlusCode is a number of up to nine digits, printed in
most TV guides next to the start time of a TV
programme.
All the information required for a programming is
contained encoded in the PlusCode programming number.
Select 'VIDEO Plus+ programming' with v (up
cursor) or w (down cursor).
T i m e r
V I D E O P l u s + p r o g r a m m i n g
T i m e r p r o g r a m m i n g
T i m e r l i s t
Press u (right cursor).
SELECT
TIMER
T o e x i t
P r e s s T I M E R
RECORDING 33