Connecting The Power Supply; Infra Red Remote Control - Philips DVD Video Player Manual

Connecting to an amplifier equipped with Dolby
Surround( )
TM
Dolby Surround sound
Connect the player to the TV and connect the player's audio Left
and Right output sockets to the corresponding inputs on the Dolby
Surround( ) Audio/Video receiver, using the audio cable supplied
TM
(6).
If your amplifier is equipped with a Dolby Digital(
Connect the player as described in the section above 'Connecting
to an A/V receiver with multi-channel decoder'.
If your TV set is equipped with a Dolby Surround(
Connect the player to the TV as described in the section above
'Connecting to a TV'.

Connecting the power supply

1 Plug the female end of the power cable supplied into the Power
connector on the rear of the player.
2 Plug the male end of the cord into an AC outlet.
Note: The player automatically adjusts to the local mains voltage.
When the player is in the "Standby" mode, it is still consuming some power.
If you wish to disconnect your player completely from the mains, withdraw the
plug from the AC outlet.
Caution: Only qualified service personnel should remove the
cover or attempt to service this device.

Infra red remote control

Installing the batteries
1 Open the battery compartment cover.
2 Insert two 'AA' (LR-6) batteries as indicated into the battery
compartment.
3 Close the cover.
Caution: Do not mix old and new batteries. And never mix
different types of battery (standard, alkaline, etc.).
) decoder
TM
) decoder
TM
PREPARATION 19