Specifications; Transmitters (Utx-B2/H2/P1) - Sony UWP-V1 Operating Instructions Manual

Specifications

Design and specifications are subject to
change without notice.
Note
Always verify that the unit is operating
properly before use. SONY WILL NOT
BE LIABLE FOR DAMAGES OF ANY
KIND INCLUDING, BUT NOT
LIMITED TO, COMPENSATION OR
REIMBURSEMENT ON ACCOUNT
OF THE LOSS OF PRESENT OR
PROSPECTIVE PROFITS DUE TO
FAILURE OF THIS UNIT, EITHER
DURING THE WARRANTY PERIOD
OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER
REASON WHATSOEVER.
Transmitters (UTX-B2/H2/
P1)
Items common to all
transmitters
Oscillator type
Crystal-controlled PLL synthesizer
Carrier frequencies
Model available in USA: 566 to 590
MHz (U30 model), 638 to 662
MHz (U42 model)
Model available in Europe: 566 to
590 MHz (CE33 model), 606 to
630 MHz (CE38 model), 638 to
662 MHz (CE42 model), 758 to
782 MHz (CE57 model), 798 to
822 MHz (CE62 model), 838 to
862 MHz (CE67 model)
Model available in Australia: 792 to
806 MHz (AU66 model)
Model available in Thailand and
Taiwan: 794 to 806 MHz (E
model)
Operating frequency band
Model available in USA and
Europe: 24 MHz BW
Model available in Australia: 14
MHz BW
Model available in Thailand and
Taiwan: 12 MHz BW
Pre-emphasis
50 µs
Distortion
1.0% or less (–60 dBV, 1 kHz
input)
Signal-to-noise ratio
60 dB or more
Tone signal
32 kHz
Attenuation
0 to 21 dB, in 3-dB steps
Display
Channel, frequency, audio level,
RF level, accumulated use time
Power requirements
3.0 V DC (two LR6/AA size
alkaline batteries)
Operating temperature
0°C to 50°C (32°F to 122°F)
Storage temperature
–20°C to +55°C (–4°F to +131°F)
Body-pack transmitter (UTX-
B2)
Antenna
λ
1/4 wave length wire
Audio input connector
3.5-mm dia. mini jack
Reference audio input level
–60 dBV (at 0 dB attenuation level)
RF output level
30 mW/5 mW selectable (for model
available in USA, Europe, and
Australia)
Specifications 51