Checking The Signaling System - Yamaha YJ50RAP Service Manual

EAS00796

CHECKING THE SIGNALING SYSTEM

1. The horn fails to sound.
1. Horn switch
• Check the horn switch for continuity.
Refer to "CHECKING THE SWITCHES".
• Is the horn switch OK?
YES
2. Voltage
• Connect the pocket tester (DC 20 V) to the
horn connector at the horn terminal as
shown.
Positive tester probe → brown 1
Negative tester probe → ground
• Set the main switch to "ON".
• Push the horn switch.
• Measure the voltage (12 V) of brown at the
horn terminal.
• Is the voltage within specification?
YES
NO
Replace the left han-
dlebar switch.
NO
The wiring circuit
from the main switch
to the horn connec-
tor is faulty and must
be repaired.
SIGNALING SYSTEM
3. Horn
• Disconnect the pink connector at the horn
terminal.
• Connect a jumper lead 1 to the horn ter-
minal and ground the jumper lead.
• Set the main switch to "ON".
• Push the horn switch.
• Does the horn sound?
7 - 32
ELEC
NO
The horn is OK.
– +
YES