Appendix B 0: System Configuration - Panasonic DBS-576 Technical Manual

Section 510: Built-In Voice Mail w/2-Way Call Recording
6. Call up Program No. 9961 by punching in:
Introduction
0
7. Select HDD #1 by punching in:
System
Configuration
FF1
System
8. Start initialization by punching in:
FF2
Trunks
FF3
Extensions
9. The display should indicate successful completion of HDD formatting.
FF4
FF-/Soft Keys
FF5
Groups
10. If the HDD formatting completed successfully, press
FF6
11. Initialize the VM Unit to default settings as follows:
TRS/ARS
FF7
Applications
FF8
12. The VM Unit should now be ready for programming.
Maintenance
Appendix A
Appendix B
576-25-510 (VM Version 2.0)
Display will read:
9961:
DISK NO. 1/2
Display will read:
9961:
START (0) QUIT (1)
•
If the HDD is not properly installed, the message "[NO HDD]" will be
displayed. Check the HDD for secure installation.
•
The display should show the HDD initialization in progress.
Display will read:
HDD FORMAT!
HDD FORMAT
•
Initialization takes approximately 3 to 5 minutes.
Display will read:
COMPLETED
HDD FORMAT
•
If a formatting error occurs, or if you don't see the COMPLETED display,
repeat HDD formatting starting at step 5. If it fails again, replace the HDD.
Programming Mode.
•
On the VSSC Card, set the SW2 dipswitch to
The SW1 dipswitch should still be set to
•
On the CPC Card in the main cabinet, push the red RESET button.
•
Watch for the LED on the VSSC Card to go on and off, then finally go solid.
•
On the VSSC Card, set the SW1 dipswitch to
DBS 576 (USA) issued March 1999
Chapter 1. Installation and Initialization
9961 Hold
1 Hold
0 Hold
ON/OFF
"ON LINE"
(down).
"INITIAL"
"BACKUP"
Introduction
1
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
to exit
FF6
TRS/ARS
(up).
FF7
Applications
(up).
FF8
Maintenance
Appendix A
Appendix B
•
1-9
Installing
& Initializing