Removing/Reinstalling Outside Panel - Sony DIGITAL BETACAM DVW-707 Maintenance Manual

1-6. Removing/Reinstalling Outside Panel

1-6. Removing/Reinstalling Outside Panel
Removing
n
Be sure to turn off the power, and then disconnect the
power cord and/or battery before performing the following
steps. If not, damage to internal circuit may result.
1. Fully loosen the left screw (with drop-safe) of the front
lid.
2. Fully loosen the four screws of the outside panel to
remove the panel.
Front lid
Screws (with drop-safe)
1-14
Reinstalling
1. Sliding the hook of the outside panel onto the guide
shaft of the cassette compartment, install the outside
panel.
2. Fasten the screws of the outside panel.
n
Tightening Torque : 140 x 10
Outside panel
Screws
(with drop-safe)
Guide shaft of the
cassette compartment
_2
N.m {14.3 kgf.cm}
Screws
(with drop-safe)
Screws (with drop-safe)
Hook of the outside panel
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P1