Parts And Their Functions - Panasonic AG-MYA30G Operating Instructions Manual

I
Ii i
Parts and their functions
OLeval control
Turn one or both of these controls to
adjust the input level of the sound.
The input levels of the CHI (Ietl
channel) and CH2 (right channel)
sound can be adjusted separately.
Normally, it is recommended that the
controls be kept at the center position.
MInimum
Maximum
E-?
• Once the unit is mounted on the AG·
HMC40P. AG-HMC41E. AG-DVC30 or
AG·DVC32, the audio levels of the mic
input signals can no longer be adjusted
using the controls on the camera-
recorder.
eXLR connectors (INPUTl. INPUT2)
Connect a microphone or audio unit
here.
E)MIC/L1NE switch
Set the switch to the position
corresponding to the unit connected to
the XLR conneclor (INPUT1 or INPUT2).
LINE:
Set the switch to LINE when an
audio unit has been connected to
the XLR connector.
The input level is 0 dBu.
At this point, set the wind noise
reduction function of the AG·DVC30
(or AG·DVC32) to OFF.
<Note>
On the AG·HMC40P (or AG-
HMC41 E) the "WIND
cur
function
automatically switches to OFF.
MIC:
Sel the switch to MIC when a
microphone has been connecled to
the
XLR
connector.
The input level can be switched
using the ATT switch
O.
OATIswitch
Use this to switch the audio input level.
ON: -50 dBu, OFF: -60 dBu
The switch setting takes effect when
the MIC/L1NE switch E) has been sel
to the MIC position.
<Note>
When using the AG·MC200G. please
put it in the ON position. If used in the
OFF position, it becomes more
sensitive and may cause noise to be
recorded.