Advanced Setup List - Yamaha YSP-2500 Owner's Manual

Advanced setup list

Menu
TURN ON VOLUME OFF (Not set) (default), 1 to 70
MAX VOLUME 1 to 99, MAX (Maximum) (default)
ON (INPUT key operation is disabled)
INPUT LOCK
OFF (INPUT key operation is enabled) (default)
ON (Key operation on the center unit is disabled)
PANEL LOCK
OFF (Key operation on the center unit is enabled) (default)
ON (Enables power-on)
IR INPUT POWER
OFF (Disables power-on) (default)
ON (Enters standby mode) (default)
AC ON STANDBY
OFF (Restores the state before power was lost)
ON (Protect is performed)
MEMORY PROTECT
OFF (Protect is not performed) (default)
YES (The reflection board is used)
YRB FL
NO (The reflection board is not used) (default)
YES (The reflection board is used)
YRB FR
NO (The reflection board is not used) (default)
YES (The reflection board is used)
YRB SL
NO (The reflection board is not used) (default)
YES (The reflection board is used)
YRB SR
NO (The reflection board is not used) (default)
ON (This unit turns off automatically) (default setting for U.K., Europe and Russia
models)
AUTO POWER STANDBY
OFF (This unit does not turn off automatically) (default setting other than U.K.,
Europe and Russia models)
02.00.04 (The firmware version is displayed)
FW UPDATE
START OK? (Firmware is updated)
OK (All settings are restored to their default values)
INITIALIZE
CANCEL (Settings are not restored to their default values) (default)
• Initializing this unit also initializes measurement results for IntelliBeam and settings stored in system memory. Perform "AUTO SETUP" from the "IntelliBeam" menu again.
Settings/Adjustable range Description
Set the initial volume level when the power of this unit is turned on.
When set to "OFF", volume level is the same as when this unit is turned off.
Set the maximum volume level so that this unit will not output sound beyond the
limited volume level.
Select whether or not to enable the INPUT key on the center unit.
Select whether or not to enable key operations on the center unit (except the
advanced setup operations).
Select whether or not to automatically turn on this unit by pressing an input selector
key on the remote control when the unit is turned off.
Set this unit's power to off when the AC power is recovered after the power to this
unit was lost temporally (disconnect the AC power plug from the wall outlet, power
outage, etc.).
Protect the settings you have saved in the system memory.
Use the YRB-100 sound reflection board for the front left channel. Refer to page 73
for details of YRB-100.
Use the YRB-100 sound reflection board for the front right channel. Refer to page 73
for details of YRB-100.
Use the YRB-100 sound reflection board for the surround left channel. Refer to page
73 for details of YRB-100.
Use the YRB-100 sound reflection board for the surround right channel. Refer to
page 73 for details of YRB-100.
When set to "ON", this unit turns off automatically in any of the following situations:
• Audio is coming from the selected input source. However, no operations have
been performed for 8 hours or more.
• Bluetooth is selected as the playback device. However, no audio has come out
from the device or no operation has been performed for 20 minutes or more.
• HDMI 1, 2, or 3 is selected as the playback device. However, the playback
device has been disconnected from the selected HDMI IN jack for 20 minutes or
more.
Confirm firmware version/update firmware.
Reset all of the parameters of this unit to the factory presets. When the unit freezed,
the problem may solve by restoring to their default values.
SETTINGS ➤ Advanced setup
66
En