Table of Contents
Advertisement
• Tool service must be performed only by qualified repair personnel. Service
or maintenance performed by unqualified personnel may result in injury. To
locate your nearest D
WALT service center call (AUS) 1800 654 155 or
E
(NZ) 0800 339258
• Do not use optical tools such as a telescope or transit to view the laser beam.
Serious eye injury could result.
• Do not place the IR thermometer in a position which may cause anyone to
intentionally or unintentionally stare into the laser beam. Serious eye injury
could result.
• Do not disassemble the IR thermometer. There are no user serviceable parts
inside.
• Do not modify the IR thermometer in any way. Modifying the tool may result in
hazardous laser radiation exposure.
• Do not operate the IR thermometer around children or allow children to
operate the IR thermometer. Serious eye injury may result.
• Do not remove or deface warning labels. Removing labels increases the risk of
exposure to radiation.
• Do not use IR thermometer for testing temperatures of cooked or uncooked
food.
• Do not use for taking of humans or animals body temperature.
CAUTION: Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
• The label on your tool may include the following symbols.
V ............................volts
mW ........................milliwatts
................Laser warning symbol
nm ..........................wavelength in nanometers
2.............................Class 2 Laser
3a ..........................Class 3a Laser
WARNING LABELS
For your convenience and safety, the following label is on your IR thermometer
(Fig. 2).
WARNING: LASER RADIATION DO NOT STARE INTO BEAM CLASS 2 LASER
PRODUCT MAXIMUM OUTPUT POWER <1mW.
WARNING: ALWAYS wear approved protective safety equipment complying with
the following standards:
• Eye protection: AS/NZS1337 Eye Protectors for Industrial Applications;
• Hearing protection: AS/NZS1270 Acoustics – Hearing Protection;
• Respiratory protection: AS/NZS1716 Respiratory Protective Devices.
WARNING: We recommend the use of a residual current device with a residual
current rating of 30mA or less.
CAUTION: When not in use, place tool on its side on a stable surface where it
will not cause a tripping or falling hazard. Some tools with large battery packs will
stand upright on the battery pack but may be easily knocked over.
Important Safety Instructions for All Battery Packs
When ordering replacement battery packs, be sure to include catalog number and
voltage. Consult the chart at the end of this manual for compatibility of chargers and
battery packs.
The battery pack is not fully charged out of the carton. Before using the battery pack
and charger, read the safety instructions below. Then follow charging procedures
outlined.
READ ALL INSTRUCTIONS
• Do not charge or use battery in explosive atmospheres, such as in the
presence of flammable liquids, gases or dust. Inserting or removing the battery
from the charger may ignite the dust or fumes.
• Never force battery pack into charger. Do not modify battery pack in any
way to fit into a non-compatible charger as battery pack may rupture
causing serious personal injury. Consult the chart at the end of this manual for
compatibility of batteries and chargers.
• Charge the battery packs only in D
• DO NOT splash or immerse in water or other liquids.
• Do not store or use the tool and battery pack in locations where the
temperature may reach or exceed 40˚C (105°F) (such as outside sheds or
metal buildings in summer).
3
WALT chargers.
E
Advertisement
Table of Contents
