Advertisement
WARNING
: Lens and bulb become hot
during use
.
• During or immediately after use, don't lay flexible floodlight flat on lens
surface.
• Don't touch lens surface when bulb is lit or immediately after use.
• Handle flexible floodlight with care around any flammable surface.
• If bulb has been lit, let flexible floodlight cool for several minutes before
changing bulb.
• Do not expose light or charger to wet or damp areas. Do not expose light or
charger to rain or snow.
• Do not wash light or charger with water or allow water to get inside light or
charger. Do not submerge light in water at any time.
• While light is in use, do not cover with cloth or other flammable materials due
to increased risk of fire.
• Before using battery and charger, read ALL instructions and cautionary markings on
charger, battery pack, and product using battery pack. This product is designed
for use with the D
WALT DC9360 36 Volt lithium ion battery only. The DC9360
E
lithium battery can only be charged with the DC9000 charger. Lithium battery and
charger safety information and instructions may also be found in other lithium ion
tool instruction manuals. Please refer to the chart on the last page of the manual.
CAUTION
: Burn hazard. To reduce the
risk of injury, charge only D
batteries. Other types of batteries may burst
causing personal injury and damage.
CAUTION
: When not in use, place tool
on its side on a stable surface where it
will not cause a tripping or falling hazard.
Some tools with large battery packs will
stand upright on the battery pack but may be
easily knocked over.
• The label on your tool may include the following symbols. The symbols and
Installing and Removing the Battery Pack (Fig. 1, 2)
NOTE: Make sure your battery pack is fully charged.
the OFF position before removing or installing
battery.
To install the battery pack into the tool handle, align the base of the tool with the
rails inside the tool's handle and slide the battery pack firmly into the handle until you
WALT lithium ion
E
hear the lock snap into place (Fig. 1).
3
their definitions are as follows:
V ................. volts
Hz ............... hertz
min ............. minutes
.......... direct current
.............. Class I Construction
...................
(grounded)
............... Class II Construction
...................
(double insulated)
CAUTION
: Make certain the switch is in
FIG. 1
BATTERY RELEASE
BUTTON
A ...............amperes
W ..............watts
...........alternating current
n o ..............no load speed
.............earthing terminal
.............safety alert symbol
.../min .......revolutions per minute
BPM ..........beats per minute
FIG. 2
Advertisement
