Mitsubishi Electric NJ-EXSA10JH Instruction Manual page 23

Do not use the
following things
Doing so may cause
scratches, corrosion,
discoloration, and
cracks.
Do not wash the main unit (doing so may cause a failure).
Inner Pot
<Clean the inner pot after it
has cooled down>
Wash the inner pot with
dishwashing liquid and a
cleaning sponge, and then
rinse it thoroughly.
* Do not wash it with a nylon surface.
Detergent other than dishwashing liquid (neutral)
Benzene, bleach, thinner, alcohol, cleanser
Steel scrubbing brush or other scrubbing brush, nylon surface of a cleaning sponge, or
cleaning sponge with nylon net
Dish washer or dish dryer
Heat Sink
<Clean the heat sink after it has
cooled down>
Wash the heat sink with dishwashing
liquid and a soft sponge, and then rinse
it thoroughly.
If the heat sink is left unclean, rust, mold
and burning may occur in addition to odor
and decay.
How to remove the heat sink
Hold the tab with one hand and
push the white lever upward
with the other hand.
How to attach the heat sink
If you do not attach the cartridge, the heat sink cannot be attached.
1
Align the
heat sink and the
of the main unit and then
insert the claws into the
2 protruding parts of the
main unit.
Claw
Protruding Part
Inner Pot
P.2
Lever Lever
Tab Tab
2
mark of the Push in the upper part until
mark it clicks.
Rice Scoop, Rice Scoop Holder, and Ladle
Wash them with dishwashing liquid and a cleaning
sponge, and then rinse them thoroughly.
Lid Packing Lid Packing
(cannot be removed) (cannot be removed)
Wash it after use Wash it after use
as it absorbs odors as it absorbs odors
easily. easily.