Connect Using Wcn 2.0 - D-Link DIR-615 User Manual

Wireless n router

Hide thumbs Also See for DIR-615:

Table of Contents

Section 5 - Connecting to a Wireless Network

Connect Using WCN 2.0

The router supports Wi-Fi protection, referred to as WCN 2.0 in Windows Vista

and Windows 7. The following instructions for setting this up depends

on whether you are using Windows Vista

and Windows 7 to configure the router or third party software.

When you first set up the router, Wi-Fi protection is disabled and unconfigured. To enjoy the benefits of Wi-Fi protection, the router must be both

enabled and configured. There are three basic methods to accomplish this: use Windows Vista's built-in support for WCN 2.0, use software provided

by a third party, or manually configure.

, log into the router and click the Enable checkbox in the Basic > Wireless section. Use the Current PIN that is

If you are running Windows Vista

displayed on the Advanced > Wi-Fi.Protected.Setup section or choose to click the Generate.New.PIN button or Reset.PIN.to.Default button.

If you are using third party software to set up Wi-Fi Protection, carefully follow the directions. When you are finished, proceed to the next section

to set up the newly-configured router.

D-Link DIR-615 User Manual

Table of Contents