D-Link DIR-615 User Manual page 35

Section 3 - Configuration
This will allow you to open a single port. If you would like to open a range of ports, refer to the next page.
Name:
Enter a name for the rule or select an application from the drop-
down menu. Select an application and click << to populate the
fields.
IP Address:
Enter the IP address of the computer on your local network that
you want to allow the incoming service to. If your computer is
receiving an IP address automatically from the router (DHCP),
you computer will be listed in the "Computer Name" drop-down
menu. Select your computer and click <<.
Private Port/
Enter the port that you want to open next to Private Port and
Public Port:
Public Port. The private and public ports are usually the same.
The public port is the port seen from the Internet side, and the
private port is the port being used by the application on the
computer within your local network.
Protocol Type:
Select TCP, UDP, Both.or.Other.from the drop-down menu.
Inbound Filter:
Select Allow. All (most common) or a created Inbound filter.
You may create your own inbound filters in the Advanced. >.
Inbound.Filter page.
Schedule:
The schedule of time when the Virtual Server Rule will be
enabled. The schedule may be set to Always, which will allow
the particular service to always be enabled. You can create your
own times in the Tools > Schedules section.
D-Link DIR-615 User Manual 31