Installing/Removing The Server Enclosure In/From The Rack - Fujitsu Primergy CX400 S2 Operating Manual

5.2 Installing/removing the server enclosure
in/from the rack
V
CAUTION!
Please observe the safety information and notes on rack mounting in
●
chapter
additional server node to the server enclosure" on page
At least two people are needed to install / remove the server
●
enclosure in the rack. (For the Japanese market, please refer to " 安
全上のご注意 ".)
Do not extend more than one unit out of the rack simultaneously even
●
if the tilt protection is in place. If several units are simultaneously
extended out of the rack, there is a risk that the rack could tip over.
Fujitsu rack systems
The rack systems from Fujitsu support the installation of PRIMERGY server
enclosures:
– PRIMECENTER rack
– PRIMECENTER M1 rack
– DataCenter rack
– 19-inch standard rack (for the Japanese market)
– 19-inch slimline rack (for the Japanese market)
I
For information on mounting the server enclosure in the rack please refer
to the Mounting Instructions provided with the Rack Mounting Kit. Further
information you find in the manual of your rack system.
For the Japanese market, please refer also to the "Rack system structure
guide".
I
Online documentation for rack installation can be found on:
http://manuals.ts.fujitsu.com/index.php?id=5406-5605-5606
(for the EMEA market)
http://jp.fujitsu.com/platform/server/primergy/manual/peri_rack.html
(for the Japanese market).
To accommodate the ventilation concept and ensure proper ventilation, any
unused areas in the rack must be sealed using dummy covers.
CX400 S2
"Important information" on page 21
Operating Manual
Hardware installation
and section "Installing an
39.
37