Oil Pan And Oil Pump Strainer Cleaning; Oil Pan And Oil Pump Strainer Installation - Suzuki Swift User Manual

6A1-26 ENGINE MECHANICAL (G13B, 1-CAM 16-VALVES ENGINE)
6) Remove oil pan (3) and then oil pump strainer (1).
2. O-ring
CLEANING
D Clean mating surfaces of oil pan and cylinder block.
Remove oil, old sealant, and dusts from mating surfaces and oil
pan inside.
D Clean oil pump strainer screen.
INSTALLATION
1) Apply sealant to oil pan mating surface continuously as shown
in figure.
"A" Sealant: 99000-31150
Sealant amount
Width "a": 4 mm, 0.16 in.
Height "b": 2 mm, 0.08 in.
2) Install O-ring (2) into cylinder block securely as shown in figure.
Install oil pump strainer (1) to cylinder block.
Tighten strainer bolt first and then bracket bolt to specified
torque.
Tightening Torque
.
(a): 11 N
After fitting oil pan (3) to cylinder block, run in securing bolts and
start tightening at the center: move wrench outward, tightening
one bolt at a time.
Tighten bolts to specified torque.
Tightening Torque
.
(b): 11 N
m (1.1 kg-m, 8.0 lb-ft)
m (1.1 kg-m, 8.0 lb-ft)