Table of Contents
Advertisement
8.5
Confirm software versions
8.6
Set clock time and perform VisiPC self-test
8.6.1
Set clock time
8.6.2
VisiPC tester and simulator
Siemens Building Technologies
Fire Safety & Security Products
1.
Run the VisiPC software.
2.
If VisiPC starts as the Visilynx 3 Tester and Simulator, select the Visilynx3
Configurator sub-program at the Switch drop-down menu, as detailed in the
VisiPC Software User Manual.
3.
On the menu bar, select Transfer and then the Versions... option. This
brings up the Software Version pop-up box.
4.
Select each software Version Type, in turn, from the drop down menu and
press the Send button. The software version is then displayed in the Version
field. (Note: Only the local node, as Node L, can currently be queried.)
5.
You can record the versions in the table below, for reference:
Version Type
Visilynx FPGA firmware
Visilynx main software
Visilynx flash boot loader
Visilynx configuration
Visilynx font
6.
You can perform any required software upgrades, by selecting the Transfer
menu command and then the Software... option, as detailed in the VisiPC
Software User Manual.
Any Configuration held in the VIS3i-328 is erased when you transfer the main
IMPORTANT
control software. You will therefore need to transfer the configuration back to the
VIS3I-328, once you have loaded the revised software.
On a new unit, we recommend that you set the internal clock on the VIS3I-328 to
the current PC time. You can do this on the VisiPC (Visilynx 3 Configurator) sub-
program. From the Transfer drop-down menu, select Date/Time.
Ensure that Current Time is ticked and select Send.
You use the features of the VisiPC Visilynx 3 Tester & Simulator sub-program to
test the functions of the VIS3I-328.
Version Reported
25
10.2008
Advertisement
Table of Contents
