Kenwood TK-260N Service Manual page 12

GND
PTT/RXD
REMOTE/TXD
2.5
Cloning cable
8. Self Programming Mode (TK-270G only)
Write mode for frequency data and signalling etc. Mainly
used by the person maintaining the user equipment.
8.1 Self programming mode setting
Remove D17 from the TX-RX unit (Figure 3) (K, E, (N)E,
K2 models only). Hold down the [Side1]+[ ] switches and
turn the power switch on.
When the self programming mode is entered, [SELF]
appears on the display. The mode changes automatically
to Model Select Mode and "PORTABLE" is displayed in
about one second.
Note :
This mode (self programming mode) cannot be set when it
has been disabled with the FPU.
Note :
Self programming is disabled if "a Trunking Board is installed
in this Radio" is selected in the FPU.
Flow Chart
Radio type
[2]
Radio Band & Channel Type
[2]
Frequency Version
[2]
[3]
Self programming mode
[Side2]
Channel set mode
Function set mode
Note :
IF the radio type of TK-270G was temporally set to "Mobile"
for the cloning purposes, "UNPROG" is displayed (at User
Mode) when the TK-270G is turned on.
REALIGNMENT
Fig. 2
Portable
[CH]
M models only
VHF 8CH VHF 16CH
[CH]
VHF F1 VHF F2
[CH]
[Side1]
TK-260G/(N)/270G/(N)
GND
PTT/RXD
REMOTE/TXD
Mobile
[CH]
VHF 128CH
[CH] [CH]
[CH]
UHF F1 UHF F2
[CH]
[CH]
In this case, please set the radio type back to "Portable" at
Model Select Mode menu.
8
1
X57-587X
Compoent Side
D17
Fig. 3
M models only
UHF 8CH UHF 16CH
[CH] [CH]
UHF F3 UHF F4
[CH] [CH]
1
MBL
PSB
GND
PTT/RXD
ME
MIC
REMOTE/TXD
8 CM
UHF 128CH
Frequency
version selection
that matches
Radio Band and
Channel Type
appears.
11