Disassembly For Repair - Kenwood TK-260N Service Manual

Separating the case assembly from the chassis.
z
1. Remove the two knobs
c
2. Remove the two screws
3. Expand the right and left sides of the bottom of the case
assembly, lift the chassis, and remove it from the case
v
assembly .
4. Taking cure not to cut the speaker lead
and case assembly, and pull the speaker lead with
n
connector .
TK-260G/(N)/270G/(N)

DISASSEMBLY FOR REPAIR

x
and three round units .
.
TK-260G
stopper
TK-270G
b
, open the chassis
b
CN3
n
Separating the chassis from the unit.
• TK-260G
1. Remove the twelve small screws
,
screws .
2. Remove the solder from the antenna terminal using a
soldering iron, then lift the unit off (X57).
• TK-270G
1. Remove the three screws
Lift the unit (X54), and rise up the connecter lever in the
/
arrow with your finger .
Remove the three hexagonal bosses
m
twelve screws .
2. Remove the solder from the antenna terminal using a
soldering iron, then lift the unit off (X57).
TK-270G
X54-
X57-
TK-260G/270G
E, (N)E only
Unsolder
X57-
m
, and the three large
.
.
Ω
, and remove the
Antenna teminal
17