Dubbing Images Stored In A Multimediacard To A Tape - JVC GR-DVM90 Instructions Manual

64
EN
Fast-Forward Button (3)
Rewind Button (2)
T O C
P US H
POWER Switch
Lock
Button
SNAPSHOT Button
Display
OP Y T O T A P E
" SN A PS H O T "
Dubbing Images Stored In A
MultiMediaCard To A Tape
Images can be dubbed from a MultiMediaCard to a tape.
1
Load a MultiMediaCard (
( pg. 12).
2
Set the POWER Switch to "
down the Lock Button located on the switch. Open
the LCD monitor fully or pull out the viewfinder fully.
3
To locate the point where you wish to dub a still
2
image, play back the tape. Stop playback at the
desired point.
4
Set the POWER Switch to "
3
down the Lock Button located on the switch. To
select a still image to be dubbed, perform Index
Playback ( pg. 49), Auto Playback (
press 2 or 3 to select the image you wish.
5
To engage Dub-Standby, press SNAPSHOT. The
message "TO COPY TO TAPE PUSH "SNAPSHOT""
appears.
6
While the message is being displayed, press
SNAPSHOT again. The selected still image is
recorded on the tape for approx. 6 seconds.
•The indicator disappears when dubbing is
complete.
NOTES:
If SNAPSHOT is pressed in step 5 when the tape's erase
protection tab is set to "SAVE", the message "COPYING
FAILED" is displayed.
The XGA image is dubbed onto the tape at 720 x 480
pixels.
You can superimpose a print frame over the selected still
image to be dubbed (
After step 4, superimpose a print frame over the still
image and go to step 5.
DUBBING
(cont.)
pg. 14) and cassette
" while pressing
" while pressing
pg. 47) or
pg. 53) and dub it to a tape.