Replacing The Hinge Covers; Display Assembly; Removing The Display Assembly - Dell Latitude X200 Service Manual

Hinge Covers and Display Assembly: Dell Latitude X200 Service Manual
1 hinge covers (2)
3. Open the display 180 degrees.
4. Push up on the hinge covers to remove them from the computer.

Replacing the Hinge Covers

1. Open the computer all the way (180 degrees) so that it lies flat against your
work surface.
2. Place the hinge covers over the display hinges:
a. The left hinge cover fits over the power button and the right hinge cover
fits over the Dell™ AccessDirect™ button. Both hinge covers pass through
the display hinges to the back of the computer.
b. Ensure that the two securing tabs on the outer edge of each hinge cover
are engaged in their respective slots.
3. Press down on the top of each hinge cover to snap the hinge covers into place.
4. Close the display.
5. Press the back of each hinge cover into the back of the computer.
NOTE: The back of each hinge cover has a tab that snaps into a slot on the
back of the computer.

Display Assembly

Removing the Display Assembly

NOTICE: Disconnect the computer and any attached devices from electrical
outlets.
file:///F|/Service%20Manuals/Dell/Latitude/x200/display.htm (2 of 7) [2/28/2004 8:24:01 AM]