Gas connection (figs. 10.2, 10.3, 10.4)
•
The gas supply must use the nearest gas inlet pipe which is located at the left or the
right hand side at the rear of the appliance .
•
IMPORTANT: Check the correct positioning of the male connector as per
pictures and always operate using two suitable spanners.
•
The unused end inlet pipe must be closed with the plug and the fibre washer.
•
The hose should not be crushed or trapped or be in contact with sharp or abrasive
edges . It should also not be subjected to corrosion by acidic cleansing agents .
The hose should also be connected in such away that it does not touch the floor and
must hang in a natural loop between the appliance and the bayonet fitting.
•
To avoid damage to the appliance gas rail inlet pipe the fittings should be tightened
using two suitable spanners .
Fitting the 1/2" BSP
(male) connector
Gasket
The male
connector is
already
fitted on the left
or right inlet pipe
Left gas
inlet pipe
1/2" BSP (male)
Fig. 10.2
Right gas
inlet pipe
Plug
Fitting the plug on the
inlet pipe terminal not used
Cooker manifold
(Right or left
inlet pipe)
Manifold
male pipe fitting
1/2" G cylindrical
Gasket (#)
(ISO 228-1) male
Plug (#)
1/2" G cylindrical
(ISO 228-1) female
(#) Already fitted on the
right or left inlet pipe
Fig. 10.3
33