Putting the handset into service
Putting the handset into service
Removing the protective cover
Inserting the batteries
The handset is supplied with the approved batteries. The batteries are not
loaded. It is first charged in the handset.
1. Removing the attachment clip (if installed)
Insert a screwdriver between the attachment clip and the battery cover (1)
and force the attachment clip outward (2) until it dislodges.
Also release the clip on the reverse side and then remove.
16
Remove the protective cover from the display before
putting the handset into service.
Note:
•
Note: Please observe the safety notes on the back cover.
•
Only use the approved batteries (
•
Open the battery compartment in a dust-free environment only.
•
Your telephone directory entries and all settings remain stored
even if you remove the batteries. The date and time settings
will be reset.
•
Only remove the batteries if it is defective. The batterie's life di-
minishes each time it is removed.
Page 19).
1
2