Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for DeWalt DW743
Summary of Contents for DeWalt DW743
- Page 1 ® DW743...
-
Page 3: Saw Bench Mode
30 29 37 38 40 39... -
Page 5: Assembly
13 14 59 57 62... -
Page 6: Checking/Adjusting 45° Bevel Position In Mitre Mode
21 61 76 75 69 70 71 45°... - Page 7 19 26 30 82 80 81 29 2 mm 3-8 mm...
-
Page 9: Specifications
E N G L I S H FLIP-OVER SAW DW743 Congratulations! EC-Declaration of conformity You have chosen a D WALT product. Years of experience, thorough product development and innovation make D WALT one of the most reliable partners for professional users. -
Page 10: Safety Instructions
E N G L I S H Safety instructions 17 Do not abuse cord When using Power Tools, always observe the safety regulations Never carry the tool by its cord or pull it to disconnect from the socket. applicable in your country to reduce the risk of fire, electric shock Keep the cord away from heat, oil and sharp edges. -
Page 11: Package Contents
E N G L I S H • Allow the motor to reach full speed before cutting. • Take the time to thoroughly read and understand this manual prior to • Raise the blade from the kerf in the workpiece prior to releasing the operation. -
Page 12: Using An Extension Cable
E N G L I S H Mains plug replacement (U.K. & Ireland only) Optional accessories • Should your mains plug need replacing and you are competent to do For use in mitre saw mode: this, proceed as instructed below. If you are in doubt, contact an WALT authorized repair agent or a qualified electrician. - Page 13 E N G L I S H Assembly for mitre saw mode - Handle to the left = engaged, for use in mitre saw mode (all angles except 0-45° mitre cross cut) Mounting the under-table guard (fig. D) - Handle to the right = disengaged, for use in saw bench mode The under-table guard (48) is fitted to the top of the saw bench table.
- Page 14 E N G L I S H Checking and adjusting the 45° bevel position in mitre mode Never use your saw in saw bench mode without the upper (fig. M1 & M2) guard correctly fitted. • Ensure that the sawhead is to its extreme left-hand position with the bevel clamp handle locked.
-
Page 15: Basic Saw Cuts
E N G L I S H • To switch the machine on, press the green start button (87). Ripping (fig. V) • To switch the machine off, press the red stop button (88). • Set the blade to the correct height. •... -
Page 16: Lubrication
E N G L I S H Optional accessories Lubrication Prior to assembling any accessories always unplug the machine. The bearings of the motor are pre-lubricated and watertight. • Slightly oil the rotating table bearing surface where it slides on the lip of Dust extraction kit (fig.