ABB ACH550 Installation Manual page 18

18
Pull the strap tight and cut the unnecessary length of the plastic
strap using a side cutter.
Note: Do not to operate the drive and router module without the
screws due to the internal connection to potential earth (PE)!
7. Connect the power cable to the green power connector of the
router module. Connect the MS/TP cable to the orange MS/TP
connector of the router module. The cable connectors are
encoded to prevent cable mix-up or reversal of polarity.
Installation of the module
5. Fix the MS/TP cable to
the module, using the wire
strap delivered in the
package.
Depending on the drive
model, the cable may be
mounted on the left or right
side of module.
6. Mount the module to
the control board of the
drive, using the two
M3x10 screws. Fasten the
screws to the both screw
holes.