D 13: Mac Frequency Table - Motorola DCT2500 Installation Manual

The Interactive Info fields are:
Field Description
IP The set-top IP address assigned by the NC 1500, in dotted-decimal format; for example,
xxx.xxx.xxx.xxx where each xxx ranges from 000 to 255.
UPM The upstream modem address. This UPM value is the same as the terminal ID assigned
by the DAC 6000. The UPM is a unique, system-generated, eight-digit integer between 1
and 16777215 displayed in hexadecimal format.
Upstream ID The set-top transmission parameter assigned by the DAC 6000. It is a four-digit value
ranging from 0000 to 9999 displayed in hexadecimal format.
Downstream ID The set-top transmission parameter assigned by the DAC 6000. It is a four-digit decimal
value ranging from 0000 to 9999 displayed in hexadecimal format.
State The state mode can be MAC CONNECT, UNCONFIG, INIT_WAIT_DC_OR_,
WAIT_LM_ACK, WAIT_SO_ACK, WAIT_LA_OR_SO, INIT_STOPPED,
RUN_WAIT-DC-OR-C, RUNNING, RUN_STOPPED, or INVALID
MAC Abort Cntr The MAC Abort Counter increments every time the MAC layer reaches the Cell Abort
Count limit. The MAC Abort Counter is reset by the successful upstream transmission of
a cell, for example, when an ACK is received by the set-top.
Good Packets Not implemented.
Error Packets Not implemented.
Socket Port State The Socket Port State can be UNUSED, OPENED, READY, RECVING, or SENDING.

d 13: MAC Frequency Table

The set-top uses a range of frequencies set by the host for upstream communications. The MAC
Frequency Table displays your frequency and signal power:
MAC FREQUENCY TABLE
FREQ
The MAC Frequency Table fields are:
Field Description
Frequency The frequency, in Hz, for an upstream channel.
Power The power level, in dBmV, used on a particular upstream channel to send data to the
RPD.
POWER
Diagnostics A-19
DCT2500 Installation Manual