Motorola V6 Service Manual page 26

Disassembly
22
2. Remove the two T5 screws for mounting the 2MP imager bracket.
Figure 12. Display Module Assembly Flex Connector
3. Use the disassembly tool to unseat the vibe motor before removing display module
assembly flex connector (see Figure 12).
4. Use the disassembly tool to unseat the display module assembly flex connector from its
socket (see Figure 12).
5. Carefully and gently lift one corner of the display module assembly out of the flip assembly.
6. Avoid damage to the electrical components on the flex while carefully removing the display
module assembly from the flip assembly.
➧
Be sure the volume/smart buttons and voice button are correctly positioned in
relation to the corresponding switches on the transceiver board. Verify operation of
the buttons after replacing the transceiver board and rear chassis assembly.
October 26, 2006
6809505A64-O
061430o