Table of Contents
Advertisement
PROGRAM
SWITCHING OFF OF A COOKING
ZONE
This function permits to set a timer from "
99
to "
" minutes for automatic turning Off the
cooking zone/s .
With the cooktop switched On:
•
Select the cooking zone and set the
desired power level .
•
Within 8 seconds, touch the timer key
CL
"
" (the led indicating the programmed
zone starts blinking) and set the timer:
– The display reads "
second digit of the timer by using
the setting selector . If the value shall
be zero touch the display and the
second digit (
Touch the display to confirm o wait
a few seconds till the programmer
automatically turns to the next step .
– When the display reads "
" indicates the second digit previously
set): set the first digit of the timer by
using the setting selector . If the value
shall be zero touch the display and
the first digit (
Touch the display to confirm o wait
a few seconds till the programmer
automatically turns to the next step .
– The program is now processed (led
indicating the programmed zone
steady lit) .
•
The time can be changed at any time
following the same procedure here
above indicated (selecting previously the
cooking zone) .
•
To program another cooking zone,
repeat as described above .
Now the program for automatic switching Off
is complete .
At the end of the countdown the cooking
zone will switch Off automatically, an acoustic
signal (beep) will sound (for 2 minute only),
00
"
" will flash on the timer display and the
led next to the heater display will blink .
Touch one of the keys to stop the beep .
16
FOR
AUTOMATIC
0-
": set the
0
) will start flashing.
-Z
" (where "
0
) will start flashing.
1
"
Z
Fig. 2.6
Fig. 2.7
Fig. 2.8
Fig. 2.9
Advertisement
Table of Contents
