EDITING A LABEL
Adding a New Line
• To end the current line of text and start a new line, press the Enter key. A carriage return
mark appears at the end of the line, and the cursor moves to the start of the new line.
• There is a maximum number of lines of text that can be entered for each tape width.
A maximum of 7 lines for 0.94" (24mm) tape, 5 lines for 0.70" (18mm) tape, 3 lines
for 0.47" (12mm) tape, 2 lines for 0.35" (9mm) tape, and 0.23" (6 mm) tape, and 1
line for 0.13" (3.5mm) tape.
• If you press the Enter key when seven lines already exist, an error message is
displayed.
• To change the character attribute of each line, refer to "Setting Character Attributes
by Each Line" on page 10.
Adding a New Block
• To create a new block of text/lines to the right of your current text, press the Shift key and
then press the Enter key. The cursor moves to the start of the new block.
A maximum of 5 blocks can be entered in one label.
Moving the Cursor
• Press the
• To move the cursor to the beginning or end of the current line, press the Shift key and
then press the
• To move the cursor to the very beginning or end of the text, press the Shift key and then
press the
Inserting Text
• To insert additional text into an existing line of text, move the cursor to the character to
the right of the position where you want to start inserting text, and then enter the additional
text. The new text is inserted to the left of the cursor.
Deleting Text
Deleting one character at a time
• To delete a character from an existing line of text, move the cursor to the character to the
right of the position you want to start deleting text, and then press the Backspace key.
The character to the left of the cursor is deleted each time the Backspace key is pressed.
If you hold down the Backspace key, the characters left of the cursor are deleted
continuously.
4
Entering and Editing Text
,
,
or
key to move the cursor by one space or line.
or
key.
or
key.