Setting Bar Code Parameters And Entering Bar Code Data - Brother 884-T09 Operation Manual

EDITING A LABEL

Setting Bar Code Parameters and Entering Bar Code Data

1
Press the Bar Code key.
Up to five bar codes can be entered on a label.
2
Select an attribute using the
the or
Characters may not appear below the bar code even when "On" is selected for
"Under#", depending on the tape width being used, the number of lines entered,
or the current character style settings.
3
Press the OK or Enter key to apply the settings.
New settings are NOT applied if you do not press the OK or Enter key.
4
Type in the bar code data.
Special characters can be entered in the bar code when
using the CODE39, CODE128, CODABAR or GS1-128
protocols. When not using special characters, go to step
7.
5
Press the Symbol key.
A list of characters available for the current protocol is displayed.
6
Select a character using the
OK or Enter key to insert the character in the bar code data.
7
Press the OK or Enter key to insert the bar code in the label.
The bar code is displayed on the text entry screen.
• The "C.Digit" (Check Digit) attribute is only available for the CODE39, I-2/5 and
CODABAR protocols.
• Press the Esc key to return to the previous step.
• Press the Space key to set the selected attribute to the default value.
• Refer to the Bar Code Settings table for a list of all available settings.
26
Creating a Bar Code Label
or
key.
or
key, and then set a value for that attribute using
key, then press the