Registering Connected Camera Using The "V.networks Controller - JVC VN-C205 Instructions Manual

Settings (Step 2 Network Settings)

2-5 Registering Connected Camera Using the "V.Networks Controller"

The connected camera can be registered with the installed "V.Networks Controller".
1.
Select [Start] [Programs] [V. NETWORKS]
start up the "V.Networks Controller".
2.
Select [File] and [New].
3.
The [New] screen will be displayed.
Notes
● Images are divided into IP fragments when set to "High Speed".
● Images will be sent at the frame rate set at VN-C205. When setting the frame rate to "High Speed",
do so upon ensuring that this does not impose excessive burden on the network. (
● Do not set to high speed for narrow bandwidth networks.
● Maximum data transmission capacity is 8 Mbps. A maximum rate of 30 fps may not be possible
for 640 x 480 images depending on the image size.
● The MTU (Maximum Transmission Unit) sizes during image acquisition are as follows.
Transmission Mode MTU Size (Bytes)
Normal 1430 Bytes
High Speed 1500 Bytes
54
[V.Networks Controller] to
Enter the [IP Address].
Note
In a DHCP environment, enter the IP
address that is assigned to this camera by
the DHCP server.
Enter the [V.Networks Name]. Do so by using
a name convenient for subsequent selection,
such as the installation location or number.
(1 to 40 characters)
A folder with the name entered in will be
created inside the folder specified here, and
recorded files will be stored here.
Select the mode for acquiring images.
Normal :
Client will send requests for each image to
VN-C205.
Set to Normal when using a narrow
bandwidth network.
High Speed:
Images will be automatically sent from VN-
C205 at the specified frame rate. A
maximum transmission rate of 30 fps is
possible for 640 x 480 images.
When sending out images to multiple
clients at the same time, however,
transmission at a rate of 30 fps for 640 x
480 images will not be possible.
☞
Page 61)
4.
Connect to VN-C205.
Note
To connect to a VN-C205 for which DHCP
setting is possible, either one of the following
environments will be required.
• Environment where no DHCP server
exists.
• Environment with a DHCP server that
clearly defines the IP and MAC addresses
assigned to VN-C205.
55